Use a small paintbrush so that you can carefully control where the paint goes. Once you’re happy with the end result of your spackling efforts you can get to work painting the area. If you do sand off more than you mean to, add a bit more spackle, smooth it out, let it dry, and sand again. Be careful not to press too hard when you’re sanding so that you don’t accidentally over-sand and cause a dent in the surface area of the spackle. The goal is to get the spackle to be completely flush with the wall. To be safe, give it at least two hours to set.Īfter the spackle is dry, sand it down with your fine-grit sandpaper. Any excess spackle on the area is okay (that’s what the sandpaper is for, after all), but try to smooth out the area as much as possible.Īllow the spackle to dry. Then use the flat surface of the knife to smooth it out. Using the sharp corner of your putty knife, scoop out a tiny amount of spackle and gently push it into the hole. Filling small nails holesįilling small nail holes is a pretty straightforward process: You can consolidate some of these tools by opting to purchase a spackle/putty knife hybrid-a tool that allows you to squeeze out spackle and smooth it onto the wall without the need to buy two separate tools. Adhesive-backed fiberglass mesh tape (for filling large holes).Paint and paintbrush (if you intend to paint over the sealed hole). You don’t need a lot of supplies to fill a nail hole-just a few basics: Supplies that you’ll need to fill nail holes Below, we’ll go over the basics of how to fill nail holes both small and large, including the tips you need to know to do the job right. As you might be able to guess, a small hole, such as one left over from a 4X6 framed print, is going to be a touch easier to deal with then the larger holes left over from heavy shelves that had to be studded into the wall. The amount of work it takes to fill nail holes depends on the size and shape of the holes themselves. Do it wrong and your attempt at a fix might look even more glaring than the original nail hole. Because whether you’re a renter who’s preparing to move out (and, hopefully, take their security deposit with them) or a homeowner who’s ready to put their house up for sale, filling nail holes is a necessary-and not always super simple-task to undertake. Looking for a beautiful coat of paint you and your family can feel good about? Consider painting with Benjammin Moore Natura, the first paint to earn the Green Good Housekeeping Seal.You’ve probably seen tips and tricks on how to hang pictures and shelves, but an equally important topic is its corollary: how to fill nail holes left behind by these efforts. If you have matching paint left from your last paint job, now's the time to break it out! Otherwise, consider buying paint that is one shade darker than the previous coat, as the paint on your walls will probably have darkened with time. Once you've filled and sanded a hole of any size, using the methods above, you'll need to paint the patched area. Once dry (usually 24 to 72 hours) sand the patch down until smooth with the wall. Point a small fan at the patched area to help the spackle dry faster. It may be necessary to apply the spackle in batches. Apply the patch to the hole you're filling and again, spackle just as you would a smaller hole. These patches, which are sold for a few dollars in the building materials section of hardware stores are typically square and range in size from 4 to 12 inches. Large Holes: For holes larger than a few inches across, opt for a wall repair patch.Once dry, sand the patched area down until the finish is smooth with the surrounding wall. Place the tape over the hole and fill with spackle, using the same technique you would use for a smaller hole. The tape, which comes in widths between 1 and 3 inches should be cut to a size just larger than the hole you're filling. Dime- or Quarter-Size Holes: Larger holes can prove harder to fill and require the use of mesh tape, which is sold in rolls, usually in the paint section of home improvement stores.Drag across the hole in a smooth, solid motion, repeating if necessary to ensure the patch is smooth with the wall. Place spackle on the edge of your putty knife and hold the knife at a 45 degree angle to the wall.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |